Carbon Fiber PETG (PETG-CF)
PETG matrix reinforced with high-modulus chopped carbon fibers for high rigidity, minimal shrinkage, and matte textured finish.
Carbon Fiber PETG (PETG-CF) Calculators
Carbon Fiber PETG (PETG-CF) (1.29 g/cm³)
Slicer Tuning & Cooling Profile
- Part Cooling Fan
- 30 - 50%
- Enclosure Requirement
- Optional
- Polymer Specific Gravity
- 1.29 g/cm³
Carbon Fiber PETG • Frequently Asked Questions
A standard 1 kg spool of 1.75 mm Carbon Fiber PETG filament yields approximately 322.3 meters (1057 feet) of printable material based on its polymer density of 1.29 g/cm³.
Optimal extrusion temperature for Carbon Fiber PETG is 240 - 260 °C with a heated bed temperature of 75 - 90 °C.
Carbon Fiber PETG enclosure status: Optional. Polymers like ABS, ASA, and Nylon emit ultrafine particles (UFPs) and VOCs and warp easily from ambient air drafts, whereas PLA and PETG print safely in open-frame printers.
Dry Carbon Fiber PETG in a dedicated filament dryer or convection oven at 65 °C for 4 - 8 hours. Store with desiccant in vacuum-sealed bags to avoid steam popping, stringing, and brittle filament.
Clean the build plate thoroughly with warm water and grease-cutting dish soap (or 99% IPA). Set the part cooling fan to 30 - 50%, ensure first-layer squish is dialed in, and use a 5mm-8mm brim for tall or sharp-cornered models.